GreenFire Wetting Agent

GreenFire Wetting Agent is Class A-B

GreenFire Wetting Agent can be used for:

• • Paper
  • Wood
  • Trash
  • Petroleum or Alcohol-based fires
  • Aircraft hangars
  • Fuel storage
  • Mechanical bays
  • Equipment
  • Any other materials or structures that could be at risk to fire

• PFAS Free
• Zero Haz-Mat clean up required
• Does not contaminate waterways
• Non-Carcinogenic
• Non-Toxic
• Zero VOC
• Zero Forever Chemicals
• NSF White Book Listed
• Food environment safe
• USDA Recognized

No special protective equipment, precautions, hazards, or extinguishing media is needed when using GreenFire Wetting Agent.

Hazards – GreenFire Wetting Agent is:

• Non-flammable
• Non-combustible
• Non-explosive
• Intrinsically flame retardant
• Non-Carcinogenic
• Non-Toxic

• CAFS (Compressed Air Foam System): 0.1% – 3%
• Conventional Foam Nozzles: 0.1% – 3%

• Proportioning Ratio: 1%-6%
• Specific Gravity: 1.06g/cc
• pH: 6.8-7.6
• Viscosity: ~36cP at 20°C (non-Newtonian varies depending on shear rate)
• Shipping Specifications: 5 gal. (19 Liters.) 55 gal. drums (208 Liters.) 275 gal. Tote (1041 Liters)
• Storage Temperature: 40°F-100°F
• Surface Tension: 32 dynes/cm

Storage: For long term use make sure GreenFire Wetting Agent is properly maintained in the approved container and stored within the recommended range, there is no shelf life.

Please Note* – If freezing occurs, thawing and subsequent stirring will make the product completely serviceable.

• Nominal Use concentration: 0.1-3%
• Specific Gravity@77F (25C): 1.06g/cc
• pH @77F (25C): 6.8-7.6
• Density: 8.51 lbs./gal.
• Viscosity @77F (25C): ~34cSt (non-Newtonian: varies depending on shear rate)
• Shipping Specifications: 5 gal. (19 Liters.) 55 gal. drums (209 Liters.) 275 gal. Tote (1041 Liters)
• Minimum use temperature: Maintain above freezing
• Storage temperature: 40°F-100F (4.5°C – 38C)
• Freezing point: 30°F (-1°C)
• Appearance: Amber liquid

The 3% can be used with conventional foam equipment with fresh, sea or brackish water.

Self inducting foam nozzles and foam nozzles with In-line inductors are among the most common types of hardware for application.

In addition to its use in aspirating foam equipment, it can be dispensed effectively through non-aspirating equipment Including fog nozzles, water spray devices and standard sprinklers.

Is effective in sub surface injection systems for non-water-soluble hydrocarbons. Sub surface injection is safe and reliable for fixed protection of storage tanks.

GreenFire Wetting Agent does NOT have a positive spreading coefficient and is therefore NOT considered an AFFF type foam.

However, its ability to form a stable foam blanket covering a fuel surface allows it to be used effectively in many applications where AFFF foams have previously been the standard.

Positive fire suppression and vapor control.

Proportions Readily: Permits use in a wide range or proportioning equipment.

Solution Stability: Solutions of GreenFire Wetting Agent do not present “transit time” limitations through handlines or in fixed systems.